The drive capacity is no longer editable after a partition is created. Remaining capacity can be used later by expanding the drive (as explained in To Expand the Capacity of a Logical Drive or Logical Volume). The remaining logical drive size capacity moves to the last partition. Note - If you do not change the Max Drive Size but you do change the Partition Size, a new partition is created at the specified partition size. A smaller logical drive can be created by decreasing this value. The Max Drive Size displays the total capacity of each disk. Select the Host channel and ID to which you would like the new logical drive to be mapped to from the Channel and the ID list boxes. If you make a mistake or change your mind, select the drive and click Remove Disk.įor definitions of RAID levels, see RAID Basics.ħ. Select a disk you want to be included in the new logical drive and click Add Disk. Verify that the server and controller displayed at the top of the window are correct.ĥ. Select Add LDs/LVs to the Current Configuration from the Custom Configuration Options window.Ĥ. Note - This selection is inactive unless you have selected an array with available physical drives.ģ. Select the array that you want to configure.Ģ.Ĝhoose Configuration Custom Configure. Note - If the logical drive is going to be larger than 253 Gbyte, see To Prepare for Logical Drives Larger Than 253 Gbyte.ġ. For more information, see Logical Volumes. Note - Logical volumes are unsuited to some modern configurations such as Sun Cluster environments, and do not work in those configurations. To add a logical volume from existing logical drives, see To Add a Logical Volume From Existing Logical Drives. Use this option to add one or more logical drives to an existing configuration of RAID sets, or to add a logical volume from new logical drives. To Add a Logical Drive or Logical Volume From New Logical Drives When you are finished with the configuration activities, log back into the monitoring level of the program. Note - To use the Configuration options, you must log into the ssconfig security level of the software with the ssconfig password. A satellite dish symbol is attached to the server icon during the refresh process. The menu command is also shown as deactivated when the console is refreshing its inventory on the server. The Configuration menu commands and tool icons might be temporarily disabled if an administration process, such as parity checking, is running.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |